Leveling of the printing bed
21 June 2022
|By Diego Villa
- Start by preheating the nozzle and bed at the desired printing temperatures, so: menu > advanced > temperature > nozzle and bed. Wait for the heating.
- Make sure that the printer is placed on a flat and stable surface. Check the leveling, so: menu > prepare > manual leveling > position.
- Follow the next procedure in this order: 01 02 03 01 02 03 00.
Change the distance between nozzle and bed to about 0.1mm by rotating the leveling wheel corresponding to the hotend position (on a Delta WASP 4070 screw/unscrew the outermost Phillips screws on the heated bed). - An higher or lower distance could cause extrusion problems or adhesion ones. A good way to ensure it is calibrated correctly is by attempting to push a sheet of paper between the nozzle and the print bed. The paper should be able to slip under without folding, but just barely.