Remotely control the printer

To print from your computer after connecting the printer to Wi-Fi, follow these steps:

NOTE: Remote connection with the Delta WASP printer is ONLY possible if the printer and PC are connected to the same network. There is no remote control from a network other than the one to which the machine is connected (e.g. Check the print from home).

CHECK THAT YOU ARE CONNECTED TO THE SAME WI-FI NETWORK: Make sure that both your computer and printer are connected to the same Wi-Fi network. This is crucial to enable communication between the two devices.

FIND THE PRINTER’S IP ADDRESS: To access the printer, you will need to know its IP address. You can find it on the printer’s control panel.

ACCESS THE CONTROL PANEL VIA YOUR BROWSER: Open your favorite web browser on your computer and enter the printer’s IP address into your browser’s URL, such as “” (actual IP address may vary). Press Enter to start the connection.

LOG IN TO THE “OCTOPRINT” PLATFORM: Once you enter your IP address in the browser bar, you will be redirected to the Octoprint platform. This allows you to monitor and control the printer remotely, printing files, controlling temperatures and the camera, etc.

To be able to access all functions, you must log in with the following credentials:

  • USER: user
  • PASSWORD: password

NOTE: Please be careful to enter your credentials in lowercase without leaving any blank spaces at the end.

If you encounter any problems or need more specific details about your printer or the software you use, I recommend that you consult your printer’s manual or contact technical support