WASP ZEN X Extruder – ZEN X Block replacement

PREPARING FOR REMOVAL:

• Make sure the machine is turned on.
• Use the “Autohome” command from the PRINT > AUTOHOME menu.
• Perform Filament Removal
• Turn off the machine.

REMOVING THE ZEN X BLOCK:

• Remove the Velcro tape.
• Remove the PTFE tubing by pushing down on the crowns and pulling up on the tubing.
• Unplug the connector
• Remove the OOZE SHIELD
• Unscrew and remove the two central-external fixing screws, keeping the extruder lock firmly locked.

• Remove the extruder block from the extruder casing.

CAUTION: The ZEN X Block must be replaced from under the extruder and may be hot. Therefore, caution is advised.

REPLACING THE ZEN X BLOCK:

• Insert the new ZEN X BLOCK from under the extruder
• Tighten the two central-external fixing screws while keeping the extruder lock firmly locked.
• Put the OOZE SHIELD back on
• Plug in the connector, making sure it’s properly inserted
• Insert the two PTFE tubes
• Put the Velcro tape back in the correct starting position and put the plastic ties back in place properly

NOTE: Self-calibration must be performed before launching a new print